WiFi Onboard | MikroTik Groove step-by-step setup guide

The MikroTik Groove is a fantastic product to use as a marine WiFi booster. However, it is not the simplest device to configure. This guide covers setting up and configuring the Groove for initial use, and some additional recommendations.

Usage

There are a couple of different ways you can use the MikroTik Groove, the most common being an outdoor “booster” to grab remote WiFi signals and pipe them to a device on board your boat belowdecks. This device is usually a router that can use the Groove as an Internet source, and then shares it out on your boat with your own personalized WiFi network.

Sometimes folks use the Groove to connect directly to a laptop instead of an internal router, but this limits other people on board from being able to take advantage of the Groove.

The Groove will not function as both a remote WiFi grabbing device, and a WiFi router where it broadcasts a local network – this is a common question I get. The Groove can either be a client and grab a remote signal, or it can be a server or access point, and serve as your local WiFi network. I wouldn’t recommend the Groove for the latter, but instead the MikroTik hAP AC – check out my article on Modular, cheaper boat internet solution via Netgear and MikroTik for more details.

Why do I need one?

Short answer: read Marina WiFi is hard.

The post MikroTik Groove step-by-step setup guide appeared first on SailBits.com.

Continue reading the full post on the Sailbits blog.

, , ,

No comments yet.

Leave a Reply

Skol!